With the continuous progress of the electrification era, various new technologies have increasingly high requirements for the stability of power transmission systems, and thus higher requirements for copper and aluminum wires. Aluminum wire has become the preferred material for high-voltage transmission lines due to its advantages such as low density, light weight, and low installation cost. As an important auxiliary material in aluminum wire drawing and aluminum alloy drawing processes, aluminum wire drawing oil's quality directly affects the quality of aluminum wire drawing products and the safety of the finished product line.
Many small and medium-sized enterprises are greedy for cheap procurement of non-standard aluminum wire drawing oil, which appears cheap on the surface but is actually more expensive to use! The following issues are usually faced. 1. Short service life During the use of wire drawing oil, the quality is poor. Due to the excessive amount of oil sludge and yellow robe, the settling performance of wire drawing oil is poor, and the oil film taken away by the aluminum wire during stretching is relatively thick, which can lead to high daily maintenance consumption. The normal service life of aluminum wire drawing oil is 6-10 months, while the service life of low-end products is only 3-4 months. The largest cable factory in Hunan that our company collaborates with uses S580A aluminum wire drawing oil combined with our specialized filtering equipment. The oil has a service life of over 4 years and does not need to be replaced, making it the aluminum wire drawing oil with a longer service life in the cable industry. 2. Fast mold loss Insufficient lubrication of the oil results in mold wear. Stable lubrication effect, high oil film strength, not only can make the surface of the wire high in brightness and without pulling marks, but also have a good protective effect on the mold to avoid mold wear; At the same time, it fully meets the high lubrication requirements during aluminum stretching, so that the finished product line has a good Surface states; Reduce friction and reduce electrical energy consumption during wire drawing. 3. High raw material loss The excellent settling ability of the wire drawing fluid can effectively ensure the rapid settling of aluminum powder in the wire drawing oil pool, maintain the cleanliness of the wire drawing fluid system and facilitate the removal of pollutants, thereby avoiding adverse effects of aluminum powder on product quality; And it is convenient for the secondary recycling and utilization of wire drawing solution. Anmei series aluminum wire drawing oil and aluminum alloy wire drawing oil, due to the use of national standard II and III base oils for blending, although slightly higher in cost compared to non-standard wire drawing oil, have excellent aluminum powder settling performance due to less oil sludge and yellow robe. They not only have a long service life, but also have good protective effects on tower wheels and molds, reducing losses. Overall, the Unit cost can be reduced by 20-40% to reduce costs and increase efficiency for customers. 4. Low safety Use low-end products with low flash point and fast evaporation of non-standard oils. Flash point, also known as flash point, refers to the minimum temperature, expressed in ℃, at which a mixture of steam and air that escapes from the heated oil product comes into contact with the flame and causes an instant flash fire under specified conditions. Low flash point, easy ignition and smoke of wire drawing oil, posing a safety hazard.
The customer originally used a certain brand of copper aluminum wire drawing oil, but the same wire drawing oil was used for large, medium, and small drawing. The produced aluminum wire is not bright enough and has drawing marks; Short service life, easy aging, and high unit fuel consumption of wire drawing oil; The environmental requirements are high, and the treatment of waste wire drawing liquid is troublesome and costly.
After switching to heavy-duty aluminum wire drawing oil and long-term heavy-duty copper wire drawing oil, the outgoing line is bright, without wire breakage, with a service life of over 4 years, without hurting hands, and solving the problem of waste liquid treatment, reducing oil consumption and waste liquid treatment costs.
