The cleaning involved in the process of industrial production is industrial cleaning. The four common types of cleaning methods are divided into physical cleaning, chemical cleaning, electrostatic cleaning and electronic cleaning. With the requirements of industrial requirements, chemical cleaning began to be replaced. The cleaning and high accuracy of cleaning are high. The only thing that is in the only beauty is to pay attention to the problem of foam. If you are not careful, you may have given up, and even cause greater trouble. So what's the way to look at industrial cleaning and removing agent. Chemical cleaning, as the name implies, is to achieve the purpose of cleaning through chemical methods. Naturally, it is inseparable from a large number of chemical auxiliary agents to assist in cooperation. It contains surfactants, which is a key factor for foaming. In addition, the cleaning products are often covered with oil -stained impurities, which are prone to cause foam in chemical reactions. Coupled with severe conditions such as high -pressure and high spraying equipment for cleaning equipment, the more the foam accumulates.
At this time, some people will ask, there will definitely be foam when cleaning things, and the more foam, the better, the better? As a result, excessive bubbles will cause the following hazards: What are the causes of industrial cleaning foam: 1. The self-rupture ability of the foam is poor, and it takes a long time to complete the purification 2. Due to the large amount of active substances in the cleaning agent, these active auxiliary agents will increase the surface tension of the liquid, which is easy to produce stable foam. 3. The powerful impact during cleaning causes the foam. The process of cleaning is sporty, the greater the water flow, the more foam accumulation is 4. The powerful wipe during cleaning causes the appearance of the bubble What are the hazards of industrial cleaning and bubbles: 1. The production of the foam causes the process of slowing industrial cleaning, affecting the production progress of the product 2. The production of foam leads to an increase in water consumption, increasing the cost of cleaning and the consumption of energy 3. Too much foam can cause environmental pollution and even endanger human health 4. The instability of product production affects the quality of the product 5. Excessive production of foam will lose the service life of the device. Bubbles may leave traces on the machine, affecting future production work Therefore, it is necessary to use a cleaning agent to solve it. After the foaming agent is exposed to the foam, it will be immediately integrated into the foam solution, and then the surface tension of the foam solution is reduced. The lower surface tension part will be trapped, extended, and then causes the foam to rupture. Washing agent's foaming agent is a foam dedicated to the foam problem of cleaning agents. This defoaming agent has the basic properties of foaming fast, long -lasting bubbles, low dosage, and does not affect the foam system. The diffusion and permeability are good, it is very easy to disperse in the water, and it can be compatible with liquid products. Good heat resistance and stable chemistry, can be used in acid, alkali, salt, electrolytes and hard water.
